How To Update Samsung Galaxy S2 I9100 with Official Jellybean 4.1.2 Firmware
Now Good
news for Samsung Galaxy S2 user, finally official Android 4.1.2 Jelly
Bean firmware for Galaxy S2 I9100. This official firmware update now
available in Spain and not other country. However, the firmware can be
used in other countries as reported by many users without any problem.
The new Android 4.1.2 Jelly Bean update that rolled out for Galaxy S2
i9100 is I9100XWLS8 Android 4.1.2 Jelly Bean. You can use your
smartphone default firmware update feature or use official Samsung tool
KIES to update your Galaxy S2 I9100 to I9100XWLS8 Android 4.1.2 Jelly
Bean firmware.
To update Samsung Galaxy S2 GT-i9100 to Android 4.1.2 Jellybean, follow our guide below.
I. Before You Begin:
1. The following procedure works for Samsung Galaxy S2 GT-i9100 smartphones.
2. Make sure your device have at least 80% battery power.
3. You must have ClockworkMod Recovery installed on your device.
4. Make sure USB Debugging is enabled
II. Downloading Required Files:
1. Android 4.1.2 Jelly Bean I9100XWLS8 for Galaxy S2 I9100
III. Install Android 4.1 Jelly Bean ROM:
1. Extract Firmware zip file and you will get a .tar file and some other files.
2. Extract Odin zip file and you will get Odin3 v3.07.exe along with few other files.
3. Switch off your Galaxy S2
4. Now, put the Galaxy S2 in Download Mode by pressing and holding the Volume Up key and Power button.
5. Then, a warning message appears, press the Volume Down key to continue.
6. Now run Odin3 v3.07.exe as an Administrator because Admin privileges is required to complete the process smoothly.
7. Now connect your Galaxy S2 with your PC using USB cable.
8. Then a message will arrive under Odin’s message box in the bottom left saying “Added!!”
9. Select these files in Odin at respective tabs from extracted firmware folder:
- Click the PDA Button, and select the .tar file here with *code* appearing in its name
- Click the Phone Button, and select file with *modem* in its name (leave if there is no such file)
- Click the CSC Button, and select file with *csc* in its name (leave if there is no such file)
- Click the PIT Button, and select the .pit file. Use only if you got it while extracting in step 1 above, otherwise ignore it.
11. Double check everything that we mentioned in Step 9 & Step 10 above. Now, once satisfied hit the START button to begin the flashing process.
12. Once flashing completed, you will see a PASS message with green background in the left-most box at the very top of the Odin. The tablet will then automatically rebooted and soon you will see the Samsung logo. You can then unplug the USB cable to disconnect your device from computer.
source
