How To Update Galaxy Note N7100 with Official Jellybean 4.1.2 Firmware
A new version
of Jellybean 4.1.2 Firmware for Samsung GALAXY
Note N7100 smartphone is now available and in the due sequence of this
article we will be checking out on how you can apply the same. Samsung
Galaxy Note 2 N7100 received N7100XXDMA5 Jelly Bean firmware update in
Thailand.
I. Before You Begin:
1. The following procedure works for Samsung Galaxy Note N7100 smartphones.
2. Make sure your device have at least 80% battery power.
3. You must have ClockworkMod Recovery installed on your device.
4. Make sure USB Debugging is enabled
II. Downloading Required Files:
1. Android 4.1.2 N7100XXDMA5 for Galaxy Note 2 GT-N7100
2. Odin 3.07
III. Install Android 4.1 Jelly Bean ROM:
1. Extract Firmware zip file and you will get a .tar file and some other files.
2. Extract Odin zip file and you will get Odin3 v3.07.exe along with few other files.
3. Switch off your tablet
4. Now, put the Galaxy Note N7100 in Download Mode by pressing and holding the Volume Up key and Power button.
5. Then, a warning message appears, press the Volume Down key to continue.
6. Now run Odin3 v3.07.exe as an Administrator because Admin privileges is required to complete the process smoothly.
7. Now connect your Galaxy Note N7100 with your PC using USB cable.
8. Then a message will arrive under Odin’s message box in the bottom left saying “Added!!”
9. Select these files in Odin at respective tabs from extracted firmware folder:
- Click the PDA Button, and select the .tar file here with *code* appearing in its name
- Click the Phone Button, and select file with *modem* in its name (leave if there is no such file)
- Click the CSC Button, and select file with *csc* in its name (leave if there is no such file)
- Click the PIT Button, and select the .pit file. Use only if you got it while extracting in step 1 above, otherwise ignore it.
11. Double check everything that we mentioned in Step 9 & Step 10 above. Now, once satisfied hit the START button to begin the flashing process.
12. Once flashing completed, you will see a PASS message with green background in the left-most box at the very top of the Odin. The tablet will then automatically rebooted and soon you will see the Samsung logo. You can then unplug the USB cable to disconnect your device from computer.
source
